Canon REALiS X700 - Manual (Page 117)

117
MAINT
ENANCE
Cleaning and Replacing the Air Filter
An air filter is installed in the air intake vent on the bottom of the main body to protect the
internal lens and mirror from dust. Should the air filter become clogged with dust, the pro-
jector may be damaged since it will block the air flow into the projector and raises the inter-
nal temperature of the projector.
Cleaning the Air Filter
Turn the projector upside down, remove the cover by pushing the latch, remove the air fil-
ter, and clean it with a vacuum cleaner.
When cleaning dust off the side exhaust vent and the bottom air intake vent, bring the vac-
uum cleaner nozzle close to them directly.
Replacing the Air Filter
1
Turn off the projector, remove the power
plug from the AC outlet, and let the pro-
jector stand for at least 1 hour.
2
Remove the filter cover by pushing the
position of the arrow.
3
Remove the air filter.
4
Install a new air filter.
5
Install the filter cover securely without any
space.
Caution
z The main unit is very hot immediately after turning off the projector. Wait until the pro-
jector cools down sufficiently (approx. 5 minutes) before cleaning the projector. Other-
wise, you may get burned or injured.
z Before cleaning or replacing the air filter, be sure to remove the power plug from the
AC outlet. Otherwise, electric shock or fire may result.
z Do not insert any object into the projector through the air filter opening. You may suffer
electric shock or injury due to the high-voltage parts or rotating parts.
z Clean the air filter frequently.
z After cleaning the air filter, install it by following the removal steps 1 to 5 in reverse.
z Attach the lens cap when replacing the air filter.
z Handle the air filter carefully. If damaged, the air filter will not work appropriately.
z Replace the air filter whenever you replace the lamp.
z An air filter can be ordered from your dealer.
Filter cover
Air filter
Push