beautypg.com

Shifting between modes, Shifting from 2h to 4a or 4h, Shifting from 4a to 4h – FORD 2007 Expedition v.3 User Manual

Page 276: Driving

background image

4L (4X4 LOW) provides electronically locked four-wheel drive when

extra power at reduced speeds is required. The RTT location in the
message center will display “4X4 LOW” when this position is selected.
This position is not recommended for use on dry pavement. Use this
position for off-road low-speed operation or when extra power is
required, such as climbing steep grades, going through deep sand or
pulling a boat out of the water.

Note: If your vehicle is equipped with AdvanceTrac

௡ with RSC, the

AdvanceTrac

௡ with RSC system will automatically turn off the stability

enhancement feature when you shift the Control Trac four-wheel drive
system into 4L (4X4 LOW). The brake traction enhancement feature will
still be enabled.

The AdvanceTrac

௡ with RSC stability enhancement system can be turned

off manually by pressing the AdvanceTrac

௡ with RSC button (refer to

AdvanceTrac

with Roll Stability Control (RSC) Stability

Enhancement System in this chapter) while operating in 2H, 4A or 4H
while driving in deep sand, very deep snow or more strenuous off-road
maneuvers. This will disable the engine management feature, allowing
the vehicle to maintain full power and enhanced momentum through the
obstacle.

Utility and four-wheel drive vehicles are not designed for
cornering at speeds as high as passenger cars any more than

low-slung sports cars are designed to perform satisfactorily under
off-road conditions. Avoid sharp turns or abrupt maneuvers in these
vehicles.

Note: The Control Trac selector knob should not be changed while the
rear wheels are slipping.

Shifting between modes

Shifting from 2H to 4A or 4H

Move the control to the 4A or 4H position at any forward speed up to
55 mph (88 km/h) or at a stop. The message center may display “4X4
SHIFT IN PROGRESS” during the system shift. The RTT location in the
message center will then display “4X4 AUTO” if 4A is selected or “4X4” if
4H is selected.

Shifting from 4A to 4H

Move the control from 4A to 4H at a stop or while driving at any speed.
The RTT location in the message center will display “4X4”.

2007 Expedition (exd)
Owners Guide (post-2002-fmt)
USA
(fus)

Driving

276