B&G H1000 Wind Interface Box - Manual (Page 5)

electrical connections
5
2 3
4 1
Front view of
male connector pins
external connections
The end of the MHU cable must be wired into the wind
interface box as per the instructions given below.
The table below shows pin functions.
Pin Number Signal
1 12V
2 Busy
3 FastNet²-
4 FastNet²+
5 0V
GROMMET
CABLE TIE
Push the cable(s) through the grommet so that the outer
insulation shows beyond the grommet and secure using
a cable tie as shown in the diagram opposite