ClearOne MAX Wireless/MAXAttach Wireless - Manual (Page 9)

CONNECTING MAX WIRELESS TO AN ANALOG PHONE LINE
Slide the cover off of the battery compartment on the bottom of the pod (as shown on left below).
Connect the battery pack plug into the port in the compartment, insert the battery pack, and slide the cover
back into place (as shown on right above).
Connect the power adapter to the conferencing pod and plug it into an electrical outlet (as shown above).
Allow the battery pack to charge at least 15 hours prior to first use.
CAUTION: Use only the power adapter that came with this unit. Using other adapters may
damage the unit.
Connect the telephone cable to the base unit and plug the other end into a wall jack. Connect the power
cable to the base unit and plug it into an AC outlet (shown below on next page).
1.
2.
3.
4.
CHAPTER 2: GETTING STARTED
CAUTION: Use only the battery pack that came with this unit. Replace only
with the same battery type as recommended by manufacturer. There is risk of
explosion if the battery is replaced with an incorrect battery. Contact ClearOne technical
support for further assistance.
Chapter 2: Getting Started 5