LaMotte SMART 2 - Manual (Page 8)

Sensitivity: Sensitivity is the resolution based on how this term is used in
LaMotte catalogs. This term is not listed in any of the references. Sometimes it
is used for detection limit. It is a confusing term and should be avoided.
Repeatability: Repeatability is the within-run precision. 6 A run is a single
data set, from set up to clean up. Generally, one run occurs on one day.
However, for meter calibrations, a single calibration is considered a single run
or data set, even though it may take 2 or 3 days.
6. Jeffery G. H., Basset J., Mendham J., Denney R. C., Vogel’s Textbook of
Quantitative Chemical Analysis, 5 th ed., Longman Scientific & Technical,
1989, p. 130.
Reproducibility: Reproducibility is the between-run precision. 7
7. Jeffery G. H., Basset J., Mendham J., Denney R. C., Vogel’s Textbook of
Quantitative Chemical Analysis, 5 th ed., Longman Scientific & Technical,
1989, p. 130.
n
CONTENTS AND ACCESSORIES
n CONTENTS
SMART2 Colorimeter
Test Tubes, with Caps
Power Supply, 110/220V
SMART2 Colorimeter Quick Start Guide
SMART2 Colorimeter Manual
n ACCESSORIES
COD Adapter Code 5-0087
UDV Adapter Code 5-0086
Small Field Carrying Case Code 1919-GCS150
Large Field Carrying Case Code 1919-BCS440
SMARTLink2 Program & Interface Cable (3.5 disk) Code 1912-3
SMARTLink2 Program & Interface Cable (CD) Code 1912-CD
n
EPA COMPLIANCE
The SMART2 Colorimeter is an EPA-Accepted instrument. EPA-Accepted
means that the instrument meets the requirements for instrumentation as
found in test procedures that are approved for the National Primary Drinking
Water Regulations (NPDWR) or National Pollutant Discharge Elimination
System (NPDES) compliance monitoring programs. EPA-Accepted
instruments may be used with approved test procedures without additional
approval.
8 SMART2 COLORIMETER 1.07