Page 8 – Blizzard Lighting Quadra ToughPAR (Rev A) User Manual

Page 8

Page 8

ToughPAR Quadra Manual Rev. A

Cable Connectors

Cables must have a male XLR connector on one end and a female XLR

connector on the other end. (Duh!)

CAUTION: Do not allow contact between the common and the fi x-

ture’s chassis ground. Grounding the common can cause a ground

loop, and your fi xture may perform erratically. Test cables with an

ohm meter to verify correct polarity and to make sure the pins are not

grounded or shorted to the shield or each other.

3-Pin??? 5-Pin??? Huh?!?

If you use a controller with a 5 pin DMX output connector, you will need to use a 5 pin to 3 pin adapter.

They are widely available over the internet and from specialty retailers If you’d like to build your own, the

chart below details a proper cable conversion:

Conductor

3-Pin Female

(Output)

5-Pin Male

(Input)

Ground/Shield

Pin 1

DMX Data (-)

Pin 2

DMX Data (+)

Pin 3

Not Used.

No Connection.

Not Used.

No Connection.

Take It To The Next Level: Setting Up DMX Control

Step 1: Connect the male connector of the

DMX cable to the female connector (output)

on the controller.

Step 2: Connect the female connector of the

DMX cable to the fi rst fi xture’s male connec-

tor (input). Note: It doesn’t matter which

fi xture address is the fi rst one connected.

We recommend connecting the fi xtures in

terms of their proximity to the controller,

rather than connecting the lowest fi xture

number fi rst, and so on.

Step 3: Connect other fi xtures in the chain

from output to input as above. Place a DMX

terminator on the output of the fi nal fi xture

to ensure best communication.