Bang & Olufsen BeoSound Ouverture - User Guide - Manual (Page 17)

17
Playing the CD
When you press the CD button to start
playing, all information on the CD – for
example the total number of tracks –
will first be registered. Then the CD
starts playing from the beginning.
While the CD is playing, you can step
through the tracks by pressing the step
buttons
▲ or ▼; or you can key in the
exact track number you want to hear,
using the number buttons.
By pressing tt or ss you can search
for a specific passage on a CD (forward
or backwards) – just as if you were
winding through an audio tape.
Searching continues for as long as you
keep your finger on the button – at a
low speed to begin with and, after 3
seconds, at a high speed. When you lift
your finger off the button, the CD
resumes playing – or pausing, if it was
paused when you started.
By means of the PAUSE and PLAY
buttons you can pause and resume
playback any time.
When the CD has been played through
once, the CD player stops – waiting for
another instruction to play.
If you select another source, the CD
player switches off automatically. To
switch off the entire system, press the
stand-by button •.
Note: If the CD player is left paused or stopped for
more than 30 minutes, the system automatically
switches to stand-by.
Starts playing the CD you have
loaded
Press to play the next track
Press to play the current track again
Press twice to play the previous track
Alternatively, key in the exact track
number you want to hear, e.g. 10
Hold down to search forward
towards the end of the CD
Hold down to search backwards
towards the beginning of the CD
Press to pause playback
Press to resume playing
Press to raise the volume
Press to lower the volume
Silences the speakers immediately
Press again to recall the sound
Switches the system to stand-by
CD
PAUSE
MUTE
PLAY
or
1
0
tt
ss
•