Bang & Olufsen BeoSound Ouverture - User Guide - Manual (Page 14)

> Using the radio
14
Fine tuning a radio station
If the sound from a radio station is not
coming through clearly, it may be
because the station needs fine tuning.
The fine tuning function enables you
to move slowly through the
frequencies, or to detune a station
slightly because of noisy reception.
To do so, just follow the instructions to
the left, and listen carefully as you
proceed...
Mono/stereo reception
The current setting is indicated in the display –
stereo or mono sound.
If you have tuned in to an FM station
broadcasting a stereo signal, this signal
will be stored along with the radio
program.
The system automatically switches to
mono if the stereo signal is not strong
enough to produce an acceptable
sound.
However, you can overrule this
automatic function if you wish, and
select mono or stereo manually. See
how to the left on this page...
Switch on to the relevant radio
program,
for example program number 5
Press to get access to the tuning
function
Press twice to display the current
mono/stereo setting
Press to switch from stereo to
mono,or vice versa
Press to store your new setting on
the program number
Switch on to the radio program you
wish to fine tune,
for example program number 5
Press to get access to the tuning
function
Press again to get access to the fine
tuning function
Fine tunes towards a higher or a
lower frequency
Press to store your fine tuning
RADIO
5
then
TUNE
TUNE
PLAY
then
then
or
RADIO
5
then
TUNE
PLAY
then
then
TUNE
PLAY
PLAY