Rockwell Automation Discrete Machine Performance Solution - Manual (Page 17)

2 • D ISCRETE MPS H ARDWARE I NSTALLATION
11
• • • • •
2 • I
n
stal
lati
on
Mounting hardware
The VersaView Integrated Display Computer is shipped with 10 mounting clips, which
are used for mounting in a panel or enclosure.
Tools required
In addition to the tools required to make the cutout, you will need a #2 Phillips
screwdriver.
Mounting dimensions
The following figures show mounting dimensions for the VersaView Integrated Display
Computer. Dimensions are in mm [in]:
The VersaView Integrated Display Computer is designed to operate at a range of extremes.
However, it is not good design practice to continuously operate the computer at the highest end
of the specified temperature range. While the product will operate at its highest specified
temperature, the overall life span of any electronic device is shortened when it operates at its
highest rated temperature.
Ensure that the humidity of the ambient air will not exceed specified limits. In very dry
environments, static charges build up very readily. Proper grounding of the equipment through
the AC power cord can help reduce the likelihood of static discharges, which may cause shocks
and damage electronic components.
Leave the computer’s enclosure or cover in place at all times during operation. The cover affords
protection against high voltages inside the computer and inhibits radio-frequency emissions that
might interfere with other equipment.
Discrete.book Page 11 Wednesday, December 8, 2004 2:22 PM