Rockwell Automation 1794-OE8H FLEX I/O HART Analog Modules User Manual User Manual

Flex i/o hart analog modules

This manual is related to the following products:

1794-IE8H FLEX I/O HART Analog Modules User Manual

Table of contents

Document Outline

Important User Information
Table of Contents
Preface
- Why Read This Manual
- Who Should Read This Manual
- About the Vocabulary
- What This Manual Contains
- For Additional Information
Chapter 1
About the FLEX I/O HART Analog Modules
- What This Chapter Contains
- What the FLEX I/O Analog I/O Modules Do
- How FLEX I/O Analog Modules Communicate with Programmable Controllers
- Physical Features of Your Analog I/O Module
- Use Alarms on the 1794-IE8H Module
- How to Use the HART Capabilities
- HART Implementation Overview
- Chapter Summary
Chapter 2
Configurable FLEX I/O Analog Module Features
- What This Chapter Contains
- Select Your 1794-IE8H FLEX I/O Analog Input Module’s Operating Features
- Select Your 1794-OE8H FLEX I/O Analog Output Module’s Operating Features
- Understand Image Table Mapping and Bit/Word Descriptions
- 1794-IE8H and -OE8H Extended Configuration Data Table
- Chapter Summary
Chapter 3
Install Your FLEX I/O Analog Modules
- What This Chapter Contains
- Before You Install Your Analog Module
- Removal and Insertion Under Power
- Install the Module
- Wire the Terminal Base Units
- Connect Wiring to the FLEX I/O HART Analog Modules
- Ground the Module
- Chapter Summary
Chapter 4
Input, Output and Configuration Files for the Analog I/O Modules on the ControlNet Network
- What This Chapter Contains
- Use Programming Software in Your FLEX I/O Application
- About the ControlNet Adapter
- Communication Over the FLEX I/O Backplane
- Fault State Data
- Device Actions
- Chapter Summary
Chapter 5
Calibrate Your Module
- What This Chapter Contains
- When and How to Calibrate Your FLEX I/O Analog I/O Module
- Tools and Equipment
- 1794-IE8H Calibration Features
- 1794-IE8H Calibration Command Structure
- 1794-OE8H Calibration Features
Chapter 6
Troubleshoot the FLEX I/O Analog I/O Modules
- What This Chapter Contains
- Status Indicators
- Repair
- Chapter Summary
Appendix A
Specifications
- 1794-IE8H HART Input Module
- 1794-OE8H HART Output Module
Appendix B
FLEX I/O HART Module Commands
- What This Appendix Contains
- Protocol Overview
- Universal Commands
- Common Practice Commands
- Device-Specific Commands
Appendix C
Additional HART Protocol Information
- What This Appendix Contains
- Message Structure
- Universal Commands
- Common Practice Commands
Appendix D
FLEX I/O HART Modules Network Messaging
- What This Appendix Contains
- Communication
- Differences Between Attributes and Assembly Indexes
- HART Frame Enhancements
Appendix E
Configure the 1794-IE8H Module in RSLogix 5000 Software Over the ControlNet Network
- What This Appendix Contains
- Background Information
- Configuration
- Input
Configure the 1794-OE8H Module in RSLogix5000 Software Over the ControlNet Network
- What This Appendix Contains
- Background Information
- Configuration
- Latch Retry Mode
- Output
- Input
Index
- A
- B
- C
- D
- F
- H
- I
- K
- L
- M
- O
- P
- R
- S
- T
- U
- W