Rockwell Automation 1746-NI8 SLC 500 Analog Input Module Instructions - Manual (Page 5)

SLC 500™ Analog Input Module 5
Publication 1746-IN006A-US-P
Electrostatic Damage
Electrostatic discharge can damage semiconductor devices inside this module if you
touch backplane connector pins. Guard against electrostatic damage by observing
the following precautions.
1746-NI8 Power Requirements
The 1746-NI8 module receives its power through the SLC 500™ chassis backplane
from the fixed or modular +5V dc/+24V dc chassis power supply. The +5V dc
backplane supply powers the SLC circuitry and the +24V dc backplane supply
powers the module analog circuitry. The maximum current drawn by the module is
shown in the table below.
When you are using a modular system configuration, add the values shown in the
table above to the requirements of all other modules in the SLC chassis to prevent
overloading the chassis power supply.
!
ATTENTION
Electrostatic discharge can degrade performance or cause
permanent damage. Handle the module as stated below.
• Wear an approved wrist strap grounding device when
handling the module.
• Touch a grounded object to rid yourself of electrostatic charge
before handling the module.
• Handle the module from the front, away from the backplane
connector. Do not touch backplane connector pins.
• Keep the module in its static-shield bag when not in use, or
during shipment.
5V dc Amps 24V dc Amps
200 mA 100 mA
@JO"VTQQE @JO"VTQQE ". ".