Installing compactblock i/o – Rockwell Automation 1791P-XXXX CompactBlock Distributed I/O on PROFIBUS DP Series D I.I. User Manual

Page 4

background image

4 CompactBlock Distributed I/O on PROFIBUS DP Series D

Publication

1791P-IN002B-EN-P - October 2003

Installing CompactBlock I/O

Follow these steps, to install the 1791P I/O module:

1. Set the Station Address on the Base Module.

2. Mount the Block(s).

3. Connect the Input/Output Wires to the Block.

4. Connect the PROFIBUS DP connector.

5. Select termination for the module.

6. Connect power to the module.

7. Remove the terminal block.

8. Insert the terminal block.

9. Communicate with the 1791P Module.

These steps are explained in detail in the following procedures.