beautypg.com

Shifted key descriptions, Powerup – Rockwell Automation 193-DNCT DeviceNet Configuration Terminal User Manual

Page 3

background image

DeviceNet™ Configuration Terminal

3

Shifted Key
Descriptions

The following table describes the alternate functionality of each key when it is pressed after the shift
key

Powerup

The DeviceNet™ Configuration Terminal is shipped so that when it is placed on the network for the
first time, it will automatically set its baud rate to that of the traffic on the network, and then assign
itself an unused network address. On power up, the following screen is displayed:

Note that there is a 10-second powerup delay programmed at the factory. The above screen will
appear for at least 10 seconds on initial powerup. The powerup delay can be modified in theTerminal
Setup screen described in the following section. Once the baud rate is determined and a network
address has been set, the terminal will display the “Network Who” screen which displays a list of all
devices on the network.

Note: If the terminal fails to enter the “Network Who” screen, after approximately 20 seconds, it is
because it could not determine the network baud rate due to lack of traffic on the network. Pressing
the ESC key will allow the user to enter the Terminal Setup screen so that a fixed baud rate and
network address can be set for the terminal.

Note: To go directly to the Terminal Setup screen, press and hold the ESC key during powerup.

Key
Combination

The letter A. Used to enter values in hexadecimal.

The letter B. Used to enter values in hexadecimal.

The letter C. Used to enter values in hexadecimal.

The letter D. Used to enter values in hexadecimal.

The letter E. Used to enter values in hexadecimal.

The letter F. Used to enter values in hexadecimal.

Copy function. Used to copy Class, Instance, and/or Attribute data to the clipboard.
Available on screens displaying a small “C” in the upper right.

Exponential function. Used to enter values in exponential notation

Paste function. Used to paste Class, Instance, and/or Attribute data from the clipboard.
Available on screens displaying a small “P” in the upper right.

Help function. Invoke help information for the current screen.

Baud = Fixed baud Rate
Auto = AutoBauding

Actual Baud Rate

Adrs = Fixed HIM MacID
Auto = Auto Addressing

Actual Terminal Address