MTS SWIFT 40 Sensor - Manual (Page 86)

SWIFT 40 Sensors 86
Test Track Vehicle
Installing the Transducer
Note If the anti-rotate assembly interferes with the mounting of the digital
inclinometer, use the alternate mounting location shown.
D. Place the digital inclinometer on the bracket and rotate the tire until the
inclinometer reads 0.0°, ±0.1° (or 90°, ±0.1° if the alternate position is
used).
E. Push the Bridge Zero button on the front of the TI box. The LED will
turn on for a few seconds, then start blinking rapidly. The Angle Zero
indicator will start blinking slowly.
F. Remove the digital inclinometer and level bracket.
G. Rotate the tire 90° in either direction.
H. Attach the level bracket so that it again sits on top of the transducer.
Insert the locking pin through the bracket and into the pin pilot hole on
the transducer.
S40-20
Digital Inclinometer
–in this position
should read 0°, ±0.1°
Level Bracket
Insert Lock Pin
in Pilot Hole
Axes
Icon
Digital Inclinometer
(alternate location)
–in this position
should read 90°, ±0.1°
S20-21
Angle Zero
Switch and Indicator
Bridge Zero
Switch and Indicator