Maintenance instructions – Marshalltown DL11 Drywall Lift User Manual
Page 13
12
Phone 800-888-0127 / 641-753-5999 • Fax 800-477-6341 / 641-753-6341 • www
.MARSHALLTOWN.com
12
Phone 800-888-0127 / 641-753-5999 • Fax 800-477-6341 / 641-753-6341 • www
.MARSHALLTOWN.com
13
BEfOrE EACh uSE:
1. Inspect the lifting cable(s) for frays, cuts or burns. If any damage is visible on the lifting
cable(s), do not use the lift.
2. Make certain winch operates freely and lifting cable(s) is not tangled on the winch drum.
3. Check cradle assembly, legs, masts and base for bends.
4. Make sure caster wheels move freely.
rECOMMENDED INSPECTION EvErY 6 MONThS:
1. Inspect the lifting cable(s) for frays, cuts or burns. If any damage is visible on the lifting
cable(s), do not use the lift.
2. Make certain winch works freely and that there are no loose or damaged parts.
WINCh MAINTENANCE:
1. Be sure that the winch cover is on the winch.
2. Check ratchet dogs and brake ratchet for wear. If any wear is visible, replace the
components. If not, lubricate both parts with a light oil.
3. For proper brake adjustment see “Troubleshooting” section on page 15.
rEPLACING ThE LIfTING CABLE(S):
1. Lower the masts to engage the safety latch.
2. Remove the large gear cover from the winch.
3. Disconnect the cable(s) from the winch drum. MAKE NOTE OF THE DIRECTION THE
CABLES ARE WRAPPED AROUND THE DRUM.
4. Remove the cradle assembly from on top of the lift.
5. Remove the mast assembly and lay it down flat on a work surface.
6. Extend the center mast up until the six allen head screws are exposed.
7. Remove the six allen head screws.
8. Slide the center and upper mast out the bottom of the outer mast.
9. Re-reeve the new cable(s) through the lift using the existing cable(s) as a guide.
10. Attach cable(s) to winch drum making sure cable(s) are wrapped in proper direction.
THE CABLES MUST BE WRAPPED IN THE DIRECTION NOTED IN STEP 3.
11. Wind the slack cable(s) tightly and evenly across the load drum.
12. Replace the center and upper mast sections into the outer mast.
13. Replace the six allen head screws.
14. Replace the winch cover.
MAINTENANCE INSTRUCTIONS