Lenze 8200 motec frequency inverter 0.25kW-7.5kW - Manual (Page 58)

Parameter setting
With keypad
6−3
L
EDB82MV752 EN 5.2
0
Function keys
Key Function Explanation
u Enable drive controller X3/28 must be set to HIGH level.
s Inhibit drive controller (CINH) or quick stop (QSP) Configuration in C0469.
t Change function bar 1 « function bar 2
xw To the right/left in the active function bar. The current function is framed.
zy Increase/decrease value.
change quickly: keep key pressed Only blinking values can be changed.
v Save parameters if
p
is blinking.
confirmation by STOre in the display.
1
Status displays
Description of the fault messages: (
^ 8−1 ff)
Display Meaning Explanation
d Ready for operation
c Pulse inhibit Power outputs inhibited
b Set current limit is exceeded C0022 (in motor mode) or C0023 (in generator mode)
e Warning active
a Error active
2
Bar graph display
Set value in C0004 in %.
(Lenze setting: device utilisation C0056). Display range: − 180 % ... + 180 % (every scale line = 20 %)
3
Function bar 1
Function Meaning Explanation
j
Setpoint selection via
yz
Not possible with active password protection (display = "loc" )
g
Display function:
·
User menu, memory location 1 (C0517/1), display
·
Display active parameter set
Active after every mains connection
f
Select codes Active code number shown on four−digit display
6
k
Select subcodes Active subcode number shown on three−digit display
7
i
Change parameter value of a (sub−) code Current value shown on five−digit display
8
h
Display values with more than 5 digits
H: high−order digits "HI" shown on display
L: low−order digits "lo" shown on display
4
Function bar 2
Function Meaning Explanation
m Select parameter set 1 ... parameter set 4 for changing
·
Display e. g. PS 2 (
5
)
·
Activating parameter sets can be effected via digital signals only
(configuration with C0410).
n Select node on system bus (CAN) The node selected can be parameterised from the current drive.
r
= function active
o Select menu
The user menu is active after every mains switching. If required,
change to
all .
user List of the codes in the user menu (C0517)
all List of all codes
funci Only specific codes for bus function modules, e.g. INTERBUS,
PROFIBUS−DP and LECOM-B