Lenze 8200 motec frequency inverter 0.25kW-7.5kW - Manual (Page 219)

Appendix
Code table
14−18
L
EDB82MV752 EN 5.2
Code IMPORTANT Possible settings
No. Selection Lenze Name
C0061* Heatsink
temperature 0 {
°C}
255 Only display
·
If the heatsink temperature is > J
max
−
5 °C:
– The warning OH will be sent.
– The chopper frequency will be
reduced to 4 kHz, if C0144 = 1
·
If the heatsink temperature is > J
max
:
– Controller sets TRIP OH
C0070 Process controller
gain 1.00 0.00
= P component not
active {0.01} 300.00 ^ 7−50
C0071 Process controller
readjustment time 100 10 {1} 9999
= I component not
active
^ 7−50
C0072 Differential
component of
process controller 0.0 0.0
= D component not
active {0.1} 5.0 ^ 7−50
C0074 Process controller
influence 0.0 0.0 {0.1 %} 100.0 ^ 7−50
C0077* Gain I
max
controller 0.25 0.00
= P component not
active {0.01} 16.00 ^ 7−56
C0078* Integral action time
I
max
controller
65
à 130
12 {1 ms} 9990
= I component not
active
à Only 8200 vector 15 ... 90 kW ^ 7−56
C0079 Oscillation damping 2 0 {1} 140 ^ 7−16
C0084 Motor stator
resistance 0.000 0.000 {0.001 W} 64.000
^ 7−48
0.0 0.0 {0.1 m W} 6500.0 Only 8200 vector 15 ... 90 kW
C0087 Rated motor speed à 300 {1 rpm} 16000 à Depending on the controller ^ 7−48
C0088 Rated motor
current à 0.0 {0.1 A} 650.0 à Depending on the controller
0.0 ... 2.0 x rated output current of the
controller
^ 7−48
C0089 Rated motor
frequency 50 10 {1 Hz} 960 ^ 7−48
C0090 Rated motor
voltage
à
50 {1 V} 500 à 230 V with 230 V controllers,
400 V with 400 V controllers
^ 7−48
C0091 Motor cos
ϕ а 0.40 {0.1} 1.0 а Depending on the controller ^ 7−48
C0092 Motor stator
inductance 0.0 0.000 {0.1 mH} 200.0
^ 7−48
0.00 0.00 {0.01 mH} 200.00 Only 8200 vector 15 ... 90 kW
C0093* Controller type xxxy Only display
·
xxx = Power taken from nameplate (e.
g. 551 = 550 W)
·
y = Voltage class (2 = 240 V, 4 = 400 V)
C0094* User password 0
= no password
protection {1} 9999 1 ... 9999 = Free access to user menu only ^ 6−7
C0099* Software version x.y Only display
x = Main version, y = Index