Kuryakyn 8828 SPLINED ADAPTER mount - Manual (Page 2)

INSTALLATION
NOTE The setscrew is not needed if a folding peg mount is desired
STEP 4 For Folding Floorboards that require a solid mount: Thread a #10-32 x 1 SSS into the upper
hole in the Adapter mount as shown in Pic. 1. Install flush with the back of the adapter.
NOTE The two (2) “D” Spring Washers have been included to take up excessive freeplay and add
tension for folding pegs in the “up position”. They will not be necessary in some instances.
Install the “D” Spring Washers on either side of the Splined Adapter Mount with the flat end
of the “D” facing inboard.
STEP 5 Install the Adapter Mount in the footpeg or floorboard mount on the motorcycle using
the hardware removed in Step 2.
NOTE The setscrew is not needed if a folding peg mount is desired
STEP 6 For folding floorboards that require a solid mount: Insert the correct size hex wrench
through the top hole in the splined face of the Adapter Mount and turn the setscrews clockwise
until they contact the footpeg mount on the motorcycle. This will “lock” the Adapter Mount in
place against the footpeg mount on the motorcycle
STEP 7 Install the new footpeg or floorboards on the Adapter Mount. Refer to the instructions
included with the new footpegs for more information.
STEP 8 Repeat Steps 1 through 7 for the other side
ATTENTION! It is the installer’s responsibility to ensure that all of the fasteners (including pre-assembled)
are tightened before operation of the motorcycle. Kuryakyn will not warranty components
lost due to improper installation. Periodic maintenance may be required.
CAUTION! Ensure that the installation of this product does not interfere with the proper operation of the
motorcycle before riding.
WARNING! IMPROPER INSTALLATION OR USE OF THIS PRODUCT COULD RESULT IN SERIOUS
INJURY OR DEATH.
PAGE
2
SPLINED ADAPTER MOUNT
PIC. 1
D-WASHER
INSTALLED
#10-32 SSS
(SEE SOLID MOUNT
FLOORDBOARD INST.)
ACCESS THE
SETSCREW FROM
THE FRONT