Adjustment procedures – Kuryakyn 6391 CRUISE-MATE MOTORCYCLE THROTTLE CRUISE ASSIST User Manual
Page 3
23 Cedarhill Rd.
Bellingham, MA 02019
877-642-3722
ADJUSTMENT PROCEDURES
CAUTION; PERFORM ALL ADJUSTMENTS WITH ENGINE OFF. ADJUSTING CRUISE-MATE WITH
ENGINE RUNNING COULD CAUSE SERIOUS DAMAGE TO ENGINE.
CAUTION; OVERTIGHTENING CRUISE-MATE COULD CAUSE THROTTLE NOT TO RETURN TO THE
CLOSED POSITION WHEN RELEASED AND RESULT IN SERIOUS INJURY OR DEATH.
Open throttle approximately half way, push CRUISE-MATE handle forward (toward front of bike) approximately ¼
turn and release throttle. If throttle doesn’t hold in position see “CRUISE-MATE TOO LOOSE” below. With
Cruise-Mate in the off position (all the way toward rear of bike) ensure that throttle operates freely and returns
to closed position when throttle is released. If it doesn’t return to closed position when released see “CRUISE-
MATE TOO TIGHT” below.
CRUISE-MATE TOO TIGHT
Throttle doesn’t return to idle position when CRUISE-MATE lever is pointing toward rear of bike.
1. Push CRUISE-MATE lever toward rear of bike.
2. Pull down on CRUISE-MATE lever and rotate lever one tooth toward front of bike (clockwise direction
looking at CRUISE-MATE from below).
3. Re-test Cruise-Mate operation as described above.
4. Repeat steps 1 thru 3 until Cruise-Mate releases control of throttle when lever is moved toward rear of
bike.
CRUISE-MATE TOO LOOSE
Throttle doesn’t hold in position when CRUISE-MATE is set.
1. Push CRUISE-MATE lever towards front of bike.
2. Pull down on CRUISE-MATE lever and rotate lever one tooth toward rear of bike (counter clockwise
direction looking at CRUISE-MATE from below).
3. Re-test Cruise-Mate operation as described above
4. Repeat steps 1 thru 3 until CRUISE-MATE holds throttle at desired position.
CAUTION; AFTER MAKING ADJUSTMENTS TO CRUISE-MATE BE SURE TO TURN THROTTLE TO FULL
OPEN POSITION WITH ENGINE AND CRUISE-MATE OFF (POINTED TOWARD REAR OF
MOTORCYCLE) TO ENSURE THROTTLE MOVES FREELY THROUGH IT’S ENTIRE RANGE.