ElmoMC SimplIQ Digital Servo Drives-Guitar Evaluation Board User Guide - Manual (Page 15)

Whistle, Bell Guitar Evaluation Board User Guide Combined Evaluation Board
MAN-EVLBRD-WHI-BEL-GUI (Ver. 1.401)
15
.8.4 Whistle Connections on the Evaluation Board
The Whistle is connected to the Evaluation Board by 2mm pitch header connectors (0.51 mm
SQ). Upon assembly, the Whistle’s J1, J21 and Power pins should be pressed directly into their
respective sockets. Great care should be taken with alignment to avoid bending the pins.
Note: All the connectors below are internal connectors.
J21
J1
PE
M1
M2
M3
VPW
VLW
PR
Internal
connector
Internal
connector