Det-Tronics U7602E Unitized UV Flame Detector/Controller - Manual (Page 16)

14
REPLACEMENT PARTS
The electronic module is not designed to be repaired in
the field. If a problem should develop, first carefully
check for proper wiring and switch setting. If it is
determined that the problem is caused by an electronic
defect, the device must be returned to the factory for
repair.
NOTE
When replacing an electronic module, be sure
that the rocker switches of the replacement are
the same as the original. Remove power before
removing the housing cover from the detector or
plugging in the replacement module.
DEVICE REPAIR AND RETURN
Prior to returning devices or components, contact the
nearest local Detector Electronics office so that a
Service Order number can be assigned. A written
statement describing the malfunction must accompany
the returned device or component to expedite finding
the cause of the failure.
Pack the unit or component properly. Use sufficient
packing material in addition to an anti-static bag or
aluminum-backed cardboard as protection from
electrostatic discharge.
Return all equipment transportation prepaid to the
factory in Minneapolis.
ORDERING INFORMATION
When ordering, please specify:
U7602E Unitized UV Flame Detector
ACCESSORIES
Part Number Description
004404-005 Swivel Mount
W8066 Portable UV Test Lamp
U7656 Hand-held UV Monitor
REPLACEMENT PARTS
Part Number Description
003240-202 DE1888B2 Module
003240-220 DE1888U2 Module*
006605-001 Electronic Module
without 4 to 20 ma output
006605-002 Electronic Module
with 4 to 20 ma output
002507-001 Window cleaner kit
002519-001 oi Ring
107427-040 O-Ring (large)
107427-004 O-Ring (small)
*High speed system only, zero time delay.