Carbolite HTR 11/150 - Manual (Page 14)

HTR
14
MF30 – 3.07
8.0 F USES & P OWER S ETTINGS
8.1 Fuses
F1-F3: Refer to the circuit diagrams.
F1
Internal
supply
fuses Fitted if supply cable fitted.
Fitted on board to some types of EMC filter. on-board and up to 16 Amps:
32mm x 6mm type F
other: GEC Safeclip
F2
Auxiliary
circuit
fuses Fitted on board to some types of EMC filter.
May be omitted up to 25Amp/phase supply
rating. 2 Amps glass type F
On board: 20mm x 5mm
Other: 32mm x 6mm
F3
Heat Light
fuses May be omitted up to 25 Amp/phase supply
rating. 2 Amps glass type F
32mm x 6mm
Customer
fuses Required if no supply cable fitted.
Recommended if cable fitted. See rating label for amperage;
see table below for fuse rating.
Access to internal fuses is by removal of the back panel of the furnace base or control box.
Model phases Volts Supply Fuse
Rating Volts Supply Fuse
Rating
HTR 11/75 1-phase 200-240 10A 110-120 16A
HTR 11/150 1-phase 220-240 12.5A 110-120 25A
other models or voltages: check the rating label for details of the supply.