beautypg.com

Echo DL12653 Instruction v.3 User Manual

Instructions, Warning, Optional trailer kit assembly instructions

background image

Instruction Sheet

Instructions

PN 77079-00

Rev. 121212

SUBJECT: TRAILER KIT FOR 12-
INCH DEBRIS LOADERS
KIT, Part # 77041-00
FITS MODELS: DL12653, DL12720

Before inspecting or servicing any part of this machine,

shut off power source, remove key, disconnect the

battery cables and make sure all moving parts have

come to a complete stop.

WARNING

OPTIONAL TRAILER KIT ASSEMBLY

INSTRUCTIONS

1. Place hitch pole into trailer frame. Do not secure into

place.

2. Route the trailer light wire harness through the hitch

pole.

3. Now, secure hitch pole to frame using two 1/2 x 4-1/2"

bolts, washers and nuts horizontally underneath the

frame and one 3/8 x 4" bolt, washer and nut vertically

at the front of the frame. Torque to 45 ft-lbs.

4. Place the triangular storage deck piece over the hitch

pole.

COUPLER

BOLT, 1/2 X 4 HEX

NUT, 1/2

CENTERLOCK

BOLT,

5/8 X 4-1/2 HEX

NUT, 5/8

CENTERLOCK

COUPLER

MOUNT

HARNESS

HITCH POLE

BOLT,

3/8 X 4 HEX

WASHER,

3/8 FLAT

NUT, 3/8 NYLOCK

WASHER,

1/2 FLAT

NUT, 1/2

CENTERLOCK

BOLT,

1/2 X 4-1/2 HEX

BOLT,

3/8 X 1 CRG

NUT, 3/8 NYLOCK

WASHER, 3/8 FLAT

BOLT,

3/8 X 4 HEX

WASHER,

3/8 FLAT

NUT,

3/8 NYLOCK

STORAGE

DECK

5. Attach the storage deck to the hitch pole using three

3/8 x 4-1-1/2" bolts, six washers and three nuts.

6. Attach the storage deck to the trailer frame using two

3/8 x 1" carriage bolts, washers and nylock nuts.

7. Next, attach wheels using four 1/2" wheel nuts per

wheel. Tighten wheel nuts alternately and torque to 75

ft-lbs. Block wheels to prevent the trailer from moving

while assembling the remainder of the parts.

8. Using the 2-1/2" snap ring, attach the trailer jack to the

hitch pole at it's location on the left side of the hitch.

9. Now, attach the safety chains to the hitch in the first

hole behind the coupler end of the hitch. Use the 3/8

x 5" bolt, two washers and nut.

10. Attach the coupler mount to the hitch pole using two

5/8 x 4-1/2" bolts and centerlock nuts.

11. Now attach the 2" coupler to the coupler mount using

two 1/2 x 4" bolts and centerlock nuts.

12. Finally, plug in license plate light and attach light in

place at the top of the license plate bracket using

two 10-24x3/4" pan head screws and nylock

nuts.

This manual is related to the following products: