Echo PE-266 - Manual (Page 13)

PE-266/S ASSEMBLY
X7502026303 13
© 6/2014 ECHO Inc.
ASSEMBLY
Drive Shaft/Power Head
1. Stand power head upright on a level surface.
2. Loosen the drive shaft clamp bolt (A) at engine drive shaft
clamp.
3. Remove dust cap if necessary, and carefully fit drive shaft
assembly to engine making sure that inner drive shaft
engages into clutch mount.
Note: Gear Housing must be aligned properly with engine.
4. Tighten drive shaft clamp bolt (A) securely.
5. Route throttle linkage and ignition lead assembly below fan
housing.
Throttle Linkage and Ignition Leads
1. Close choke and remove air filter cover.
2. Place throttle linkage (C) through adjustment fixture (D) and
install wire end into large carburetor throttle swivel hole (E).
Check throttle for freedom of movement and that wide open
throttle / low idle extremes are adjusted properly. The
throttle linkage must be adjusted by moving the adjustment
fixture (D). Consult with your Echo Dealer for correct
adjustment procedure.
3. Connect 2 ignition stop leads (F, G) from throttle cable
tubing to 2 ignition leads (F, G) on engine.
Parts Required: Power Head, Drive Shaft Assembly
I
A
C
D
E
F
G