Echo DL12725 Instruction v.1 - Manual

Instruction Sheet
The debris loader lights kit consists of two halogen lamps.
The assembly slides into the debris loader hose support
and connects to the engine wire harness.
INSTALLATION
Unplug the on/off switch from the light kit wire 1.
harness.
Insert the light assembly into the round hose support
2.
tube.
Route the wire harness through the fan housing as
3.
shown in Figure 1.
Route the two switch plugs through the rectangular
4.
hole shown in Figure 2.
Reconnect the switch to the two plugs.
5.
Push the switch into the rectangular hole (Figure 3). It 6.
will snap into place.
Route the wire harness to the right side of the
7.
engine.
Plug the light kit wire harness into the engine harness
8.
as shown in Figure 4.
Using zip ties, fasten the light kit wire along the
9.
engine.
Instructions
PN 75758-00
Rev. 030408
SUBJECT: Debris loader lights kit
KIT # 75754-00
FITS MODEL: DL12725
Before inspecting or servicing any part of this machine,
shut off power source, remove key, disconnect spark
plugs and make sure all moving parts have come to a
complete stop.
WARNING
Figure 1, Light kit harness routing
Figure 2, Reconnecting the on/off switch
Figure 3, Installing the on/off switch
Figure 4, Connecting to power source