JLG M400 ANSI Service Manual - Manual (Page 20)

SECTION 1 - SPECIFICATIONS
1-6 – JLG Lift – 3121125
1.15 SERIAL NUMBER LOCATIONS
For machine identification, a serial number plate is affixed
to the left rear of frame, in front of left rear wheel. If the
serial number plate is damaged or missing, the machine
serial number is stamped on the top left side of the frame
and the top left side of the turntable. In addition, the serial
number is stamped on top of the end of the upper boom,
mid boom, and lower boom at the left rear of the booms.
1.16 LUBRICATION
NOTE: Hydraulic oils must have anti-wear qualities at least
to API Service Classification GL-3, and sufficient
chemical stability for mobile hydraulic system ser-
vice.
Aside from JLG recommendations, it is not advisable
to mix oils of different brands or types, as they may
not contain the same required additives or be of
comparable viscosities. If use of hydraulic oil other
than Mobil DTE 11M is desired, contact JLG Indus-
tries for proper recommendations.
Lubrication Specifications
NOTE: Refer to Lubrication Chart, Figure1-2, for specific
lubrication procedures.
Table 1-16. Hydraulic Oil
Hydraulic System
Operating
Temperature Range
S.A.E. Viscosity
Grade
+0 o to + 180 o F(-18 o to +83 o C)
10W
+0 o to + 210 o F(-18 o to +99 o C) 10W-20, 10W30
+50 o to + 210 o F(+10 o to +99 o C) 20W-20
Figure 1-1. Serial Number Locations
Table 1-17. Mobil DTE 11M Specs
ISO Viscosity Grade #15
Gravity API 31.9
Pour Point, Max -40°F (-40°C)
Flash Point, Min. 330°F (166°C)
Viscosity
at 40° C 15 cSt
at 100° C 4.1 cSt
at 100° F 80 SUS
at 210° F 43 SUS
cp at -30° F 3.200
Viscosity Index 140
Table 1-18. Mobil EAL H Series Specs
Type Synthetic Biodegradable
ISO Viscosity Grade 32
Specific Gravity .950
Pour Point -59°F (-51°C)
Flash Point 514°F (268°C)
Weight
7.64 lb. per gal.
(0.9 kg per liter)
Viscosity
at 40° C 33.1 cSt
at 100° C 6.36 cSt
Viscosity Index 147