JLG 15SP Service Manual - Manual (Page 11)

SECTION 1 - SPECIFICATIONS
3120775 – JLG Lift – 1-1
SECTION 1. SPECIFICATIONS
1.1 CAPACITIES
Hydraulic Oil Reservoir
DC Models - 5 qts. U.S. (4.7 ltr.)
1.2 COMPONENT DATA
Hydraulic Pump/Electric Motor Assembly
DC MODELS - 12 VOLT DC MOTOR/PUMP
Motor - 12v - DC Standard Duty
Pump Displacement - .098 cu. in./rev.(AFC 1.6 cc/rev.)
Pump Output - 1.42 GPM @ 800 PSI @ 11.7v-DC @
135 AMPS @ 45 Centistrokes (200 SSU)
Pressure Relief - Adjustable Range 1500 to 5000 PSI,
Set to 2800 PSI (193 bar) at factory
Batteries
WET (Standard)
12 Volt - 165 Amp (min.) - Deep Cycle Marine - RV
DRY (Option)
12 Volt - 165 Amp (min.) - Deep Cycle Marine - RV
AGM (Absorption Gas Mat) (Option)
12Volt - 100 O.A.H. - M2 Marine Combination
Battery Charger
110/240 Volts AC, 50/60 Hz - input
12 Volt DC, 10 Amp - output
Automatic SCR Charger
Selectable Voltage
NOTE: A high output - 12Volt DC, 20 Amp output - SCR
charger is supplied with the AGM battery option.
1.3 PERFORMANCE DATA
Platform Capacity (Max. Rated Load)
12SP & 15SP - 500 lb.* (227kg) - ANSI-U.S.A./
Latin America
12SP & 15SP - 400 lb.* (181kg) - CSA - Canada
* Evenly distributed on platform floor.
* Extendible Platform - Max. 250 lb. on rear/250 lb. on
front, when extended. Not Available for CSA.
Machine Speeds
12SP - Lift up - 25 seconds *
Lift down - 13 to 20 seconds *
15SP - Lift up - 30 seconds *
Lift down - 18 to 25 seconds *
* Timed with maximum rated load: 500 lb.
Machine Weight (With Standard Platform)
12SP - 1,180 lbs. (535 kg)
15SP - 1,240 lbs. (563 kg)
Machine Height (Platform Stowed)
12SP & 15SP - 78 in. (1.9 m)
Maximum Platform Height (Mast Fully Extended)
12SP - 11 ft. 7 in. (3.53 m)
15SP - 15 ft. 2 in. (4.62 m)
Maximum Working Height (Average Person)
12SP - 18 ft. (5.4 m)
15SP - 21 ft. (6.4 m)
Machine Overall Width And Length (Stowed)
12SP - 34 in.(W) x 73 in.(L) (86 cm x 185 cm)
15SP - 34 in.(W) x 75.5 in.(L) (86 cm x 192 cm)
(Length includes platform and battery pack, end to end.)
1.4 TORQUE REQUIREMENTS
When maintenance becomes necessary or a fastener has
loosened, refer to the Torque Chart, Table 1-2. to deter-
mine proper torque value.