Apple ImageWriter II - Manual (Page 3)

Chapter 2: Basic ImageWriter II Setup
This chapter shows you how to
unpack your ImageWriter II
plug in the power cord
install the ribbon
load paper
run the ImageWriter II’s self-test.
Once you have set up your ImageWriter II, you’re ready to connect it to your Apple computer. (If you
have an ImageWriter II SheetFeeder, you might want to connect it, too.)
Unpacking the ImageWriter II
If you haven’t already done so, remove the ImageWriter II from its carton. Reach under the printer with
both hands and lift upward. For the moment, put the printer in a work area where you can easily get to its
back side. Then follow these steps.
Remove all packing materials from the printer and return them to the carton. Save your shipping carton
and packing materials, in case you need to store or ship your printer.
Place the printer ribbon and power cord beside the printer.
Black Ribbon and Power Cord
Remove all pieces of tape from the printer.
Take off the front cover by grasping its sides (at the arrow icons) and lifting upward.
Removing the Front Cover
Slip the two retainer tubes from the carrier rod. The retainer keeps the print head from sliding around
during shipping. Save them with your other packing materials.
Removing the Print Head Retainer Tube
Looking for Power Sources:
When considering where to put your Apple system, keep in mind that the ImageWriter II requires its own
power source. Depending on which Apple system you have, you may need three or more electrical
outlets nearby—one each for the computer, monitor, and printer. Many people prefer to plug their
computer equipment into a special power strip, equipped with protection against surges in electrical
current. See your authorized Apple dealer for information about power strips.
Electrical equipment may be hazardous if misused. Operation of this product, or similar products, must
always be supervised by an adult. Do not allow children access to the interior of any electrical product and
do not permit them to handle any cables.
Installing the Ribbon Cartridge
The black ribbon (provided with your ImageWriter II) and the color ribbon (purchased separately) are both