BT studio 2300 SMS - Manual (Page 37)

On-Air 2300 SMS user guide ~ Edition 3.1 ~ 16th August ’02 ~ 4698
36
A total REN of 4 is allowed per telephone line.
(For example: if the BT On-Air Executive is used
in conjunction with three extension telephones,
each with a REN of 1, then the total REN = 4)
Only use approved power supply item code
872101.
RTTE
This apparatus was designed in compliance with
European Council decision Number 98/482/EC
relative to pan-European connection in view to
its connection on the Public Switched Telephone
Network (PSTN). It is in conformity with
Standards TBR21, TBR38(*)ETSI 201 121.
(*) Terminals integrating an analogue handset function.
If problems arise, your supplier should be
contacted first.
The EC marking attests product conformity with
the essential requirements in compliance with
Directives 73/23/EC for User Safety, 89/336/EC
for Electromagnetic perturbations and 98/13/EC
for Telecommunication network access.
The manufacturer declares that the products
have been manufactured in conformity with
Annex III of RTTE Directive 99/05/EC.
Helpline
If you are experiencing difficulty, please call
the BT On-Air Helpline on 0870 240 4682.
Generally this telephone may be connected to
switchboards which support tone signalling and
timed break recall. In the event of any
difficulties please consult your switchboard
service provider. Please note this product does
not support earth recall.
Switchboard compatibility
To activate Recall
This is of use when connected to
switchboards or using BT Select
Services. It is only available when a call
is in progress.
When you need to use recall during
a call:-
Press the button.
Press the button when R appears
above on the display.
Recall
When connected to some switchboards/
PBX’s you may encounter higher than
normal speech levels. If this is the case
you can alter the network setting from
PSTN to PBX which will reduce the
levels to normal
Press the UP button to select Base.
Press OK.
Press the DOWN button to select
Base Settings
.
Press OK.
Press the DOWN button to select
Phone line
.
Press OK.
The display will show Line type.
Press OK.
Use the UP or DOWN button to select
either Public for PSTN or Private for
PBX.
Press OK to confirm.
To change the network connection
▼
C OK
▲
C OK
▼
C OK
C OK
▲
▼
C OK