Billion Electric Company BiPAC 7401V(G)PX - Manual (Page 4)

Quick Start Guide
-2-
Hardware Overview
The Front LEDs
The Rear Ports
Connect the
supplied power
adapter to this jack
Connect this port to the
ADSL/telephone network
with the RJ-11 cable
(telephone) provided.
Press it to reset
the device or
restore to factory
default settings
Connect a UTP Ethernet
cable (Cat-5 or Cat-5e) to
one ofthe LAN ports when
connecting to a PC or an
office/home network of
10Mbps or 100Mbps.
Connect the
detachable
antennato this port.
Lit when power is ON.
Lit red means system
failure.
Connect this port to
the telephone jack on
the wall with RJ-11
cable.
Lit when connected to an
Ethernet device.
Green for 100Mbps;
Orange for 10Mbps.
Blink when data is
Transmitted / Received.
Lit green when the
phone is off hook.
Lit Green when the device is
successfully connected to an
ADSL DSLAM. (“line sync”)
Lit green when a
wireless connection is
established. Flash
when the device is
sending/receiving data.
Power
ON/OFF
switch
Lit red when WAN port fails to
get IP address.
Lit green when WAN port gets
IP address successfully.
Lit when the inbound
and outbound calls
are transmitted
through PSTN.
Lit green when the
SIP Registration is
OK.
Push WPS button to
trigger Wi-Fi Protected
Setup function.
Connect this port to
an analog phone set
with RJ-11 cable.
Lit green when the
USB device is ready.
Flashes when
sending/ receiving
data.
3G/ HSDPA USB
modem backup for
Internet access