Heater wiring – American Water Heater ABCG3 User Manual

Page 21

Text mode
Original mode

FIGURE 9 - SINGLE UNIT WIRING DIAGRAM

HEATER WIRING

All electrical work must be installed in accordance with the current
version of the National Electrical Code ANSI/NFPA No. 70, must
conform to all local code authority having jurisdiction.

ELECTRICAL GROUND IS REQUIRED TO REDUCE RISK OF
ELECTRICAL SHOCK OR POSSIBLE ELECTROCUTION.

If any of the original wire as supplied with the appliance must be
replaced, use only type 105°C thermoplastic or equivalent.
250

C type F must be used for the flame sensor leads and the

spark ignition cable must be high voltage 250°C.