Kramer Electronics VP-773 - Manual (Page 51)

46 VP-773 - Controlling the VP-773
8 Controlling the VP-773
The VP-773 can be controlled via:

The front panel buttons (see Section
8.1
)

The OSD menu (see Section 8.2 )

The Web pages (see Section 8.3 )

The infrared remote control transmitter (see Section 8.4 )
8.1 Controlling via the Front Panel Buttons
The VP-773 includes the following front panel buttons:

Input selector buttons for selecting the required input: HDMI (1 to 4), PC
(1 and 2), CV and DP (see Section
8.1.1
)

PIP, BLANK and FREEZE buttons (note, these buttons illuminate when
selected)

MENU (left arrow), ENTER (right arrow), and up, down, arrow buttons

Output volume up (+) and down (-) buttons (when not in the OSD mode)

RESET TO XGA/720p and PANEL LOCK buttons
8.1.1 Using the INPUT Front Panel buttons
When selected, an INPUT front panel button behaves as follows:
Selecting the: Causes the button to:
Main input button Illuminate continuously
PiP input button Blink (the light On period is shorter than the light Off period)
Same Main input button and
PiP button Blink (the light On period is longer than the light Off period)
If you want to adjust the image of a selected input in a window, press
that input button again (up to 3 times) for fast tuning. Pressing that
input button for the fourth time initiates full tuning of the window.
8.2 Controlling via the OSD Menu
You can change PiP Window parameters, main window parameters and entire
system parameters via the OSD menu, as described in Section
6.8
.
i