Rivera Primo 1056-0002 Pro Clutch (PC-10000-A) - Manual (Page 2)

2
SAFETY FIRST
When performing work on any motorcycle, and prior to starting this installation
disconnect BOTH battery cables! If the motorcycle is on a lift, fasten it securely to
prevent it from falling! Read and become familiar with the Pro-Clutch TM instructions
before starting. For safety, use only the proper tools for this installation!
STEP 1:
This is the Rivera Primo Pro-Clutch TM . Get familiar
with it before disassembling it for installation! Strip
the clutch basket of all the OEM clutch components
such as bearing cage & bearings, clutch plates,
pressure plate, coil springs etc!
Note the position of the new lock-clips P/N1058-0106
STEP 2:
To prepare the Pro-Clutch TM for installation disassemble the pressure plate
assembly and clutch pack while noting the exact sequence of the components for reference during
reassembly! See the exploded view on page 6 of this installation guide.
STEP 3:
Remove the 6 Allen head bolts and the lock-ring at
the rear of the adapter! Keep track of ALL the Allen
bolts!
STEP 4: Install the Rivera Primo Pro-Clutch TM hub & adapter into the OEM clutch basket. Use Rivera
Primo’s “Blue” thread lock on the Allen bolts and tighten to 80 INCH POUNDS (not foot pounds!)
4A 4B 4
Install the adapter into the basket! Install the lock-ring on the rear of the adapter!!
1058-0111 (pair)
1058-0106 (individual)
1 1A
3
PC-1000-A PRO-CLUTCH INSTRUCTIONS_PC-1000-A PRO-CLUTCH#2A72D0.qxd 2/15/12 4:03 PM Page 2