Minka Group F689-WH - Manual (Page 22)

SYMPTOM
Fan Wobble
SOLUTION
NOTE:All blade sets are grouped by weight. Because wood and plastic
blades vary in density, the fan may wobble even though blades are
matched.
Make sure outlet box is secured to building structure, if necessary use
the wood screws provided to further secure outlet box to joist.
Make sure hanger bracket is secure to the outlet box, screws are tight.
Use the balancing kit provided if the wobble is excessive (follow
instructions included with balancing kit)
SYMPTOM
Fans/Light Turn on and Off Unexpectedly
SOLUTION
This is caused by interference. Please see “Freduency interference” for step
to charge the frequency.
SYMPTOM
Frequency Interference
SOLUTION
1.Turn the power off to your ceiling fan.
2.Please use a small size tool to change the frequency settings on the control
system.
3.Return power to the unit.
Note:After the AC power is on, do not press any other button on the
transmitter before pressing the “Stop” button,doing so will cause the
procedure to fail.
4.Within 60 secounds of turning the fan’s AC power ON. Press the
transmitter’s “Stop” button and hold the “Stop ” button for 10 seconds.
i
5.Once the receiver has detected the set frequency, the down light of your fan
if applicable will blink twice.(there is no indication if your fan is not equipped
with a light).
6.The receiver has now learn the frequency which has been selected on the
transmitter. After completing the steps above,you should be able to operate
the ceiling fan and light. If the fan is not responding to the transmitter. please
turn the power off to the receiver,and repeat the process.