Avital MAXX2 User Manual

Page 18

®2002 Directed Electronics, Inc.

■

Turn the ignition key to the ON position, then press and

release your Valet switch 17 times. You will hear a chirp

each time you press the switch to help you count.

■

When you reach branch number 17, stop and follow the

instructions in the “Secondary Action” column in the

programming table.

Example: If you would like the first two digits of your new code

to be one and one you would press button

once and

button once. To enter the digits zero and zero you would press

the

and

buttons together and go to the next step.

To enter the next two digits press the Valet switch once (you

will hear one chirp) to move from program branch number 17

to 18. Stop and follow the instructions in the "Secondary

Action" column in the programming table.

Example: If the last two digits of your new code are two and

two then press the

button twice and the

button twice.

To enter the digits one and zero, you would press the

button once and then go to step five. The system will assume

the second digit is a zero as you did not press the

button

to enter a number.

If you are satisfied that the code you entered is the correct

one then turn off the ignition to exit programming and test

your new code. Should you make a mistake during any part of

this procedure, then simply turn off the ignition and begin the

sequence again. The system will revert to the original code.