Maintenance and care – Karcher WD 5-500 M User Manual
Page 19
– 10
If the filter cleaning indicator is red, initiate
the filter cleaning.
Illustration
Insert the suction hose with the handle
into the accessory compartment on the
appliance head. Press the efficient filter
cleaning key 3 x times with the appli-
ance switched on; wait 4 seconds be-
tween the individual presses.
Note: If the filter cleaning display is illu-
minated permanently or after the filter
cleaning switch has been activated sev-
eral times, check the reservoir for its fill
volume. Otherwise, the dirt might es-
cape when the container is opened.
Cleaning hard to reach locations or, where
vacuuming is not possible, like leaves from
a gravel bed.
Illustration
Connect the suction hose to the blower
connection, this will activate the blower
function.
Turn off the appliance.
Illustration
Hook the floor nozzle into the parking
position.
Turn off the appliance and disconnect
the mains plug.
Illustration
Remove the appliance head and empty
the reservoir filled with wet or dry dirt.
For appliances with drain screw:
Empty the dry dirt over the container.
Use the drain screw to empty liquids.
Illustration
Stow away the mains cable and acces-
sory at the machine. Store the appli-
ance in a dry room.
ƽ
Danger
Turn off the appliance and remove the
mains plug prior to any care and mainte-
nance work.
Repair works may only be performed by the
authorized customer service.
ṇ
Caution
Do not use abrasives, glass or universal
cleaners! Never immerse the appliance in
water.
Clean the appliance and accessory
parts made of plastic with a commercial
plastic cleaner.
If required, rinse the container and ac-
cessories with water properly and dry
them before reuse.
Illustration
Only clean the cartridge filter under run-
ning water; do not wipe or brush. Let it
dry completely prior to installation.
Efficient filter cleaning
Blowing function
Interrupting operation
Finish operation
Empty the container
Storing the appliance
Maintenance and care
19
EN