beautypg.com

Device is not sucking in detergent, Burner does not start, Warranty – Karcher HDS 13-20-4 SX User Manual

Page 35: Accessories and spare parts, Warranty accessories and spare parts

background image

– 13

If detergent tank is empty, refill.

Check connections and conduits.

Pressure is set to MIN

Set pressure to MAX.

Sieve in the water connection is dirty

Clean sieve.

Clean the fine filter; replace it, if neces-
sary.

Amount of water supply is too low.

Check water supply level (refer to tech-
nical data).

Pump leaky

Note: 3 drops/minute are allowed.

With stronger leak, have device
checked by customer service.

Leak in the high pressure system

Check high pressure system and con-
nections for tightness.

Leave device running with open deter-
gent dosage valve and closed water
supply, until the swimmer tank is
sucked empty and the pressure falls to
"0".

Open the water supply again.

If the pump still is not sucking in any deter-
gent, it could be because of the following
reasons:

Filter in the detergent suck hose dirty

Clean filter.

Backflow valve stuck

Remove the detergent hose and loosen
the backflow valve using a blunt object.

System care bottle empty.

Replace the system care bottle.

Fuel tank empty.

Refill fuel.

Water shortage

Check water supply, check connec-
tions.

Clean sieve in the water shortage safe
guard.

Fuel filter dirty

Change fuel filter.

No ignition spark

If device is in use and no ignition spark
can be seen through the viewing glass,
have device checked by customer ser-
vice.

Working pressure/flow rate to high

Reduce working pressure/flow quantity
at the pressure/volume regulator in the
pump unit.

Sooty heating spiral

Have device de-sooted by customer
service.

If malfunction can not be fixed, the de-
vice must be checked by customer ser-
vice.

The warranty terms published by our com-
petent sales company are applicable in
each country. We will repair potential fail-
ures of the appliance within the warranty
period free of charge, provided that such
failure is caused by faulty material or de-
fects in fabrication.

Only use accessories and spare parts
which have been approved by the man-
ufacturer. The exclusive use of original
accessories and original spare parts
ensures that the appliance can be oper-
ated safely and trouble free.

At the end of the operating instructions
you will find a selected list of spare parts
that are often required.

For additional information about spare
parts, please go to the Service section
at www.kaercher.com.

Device leaks, water drips from the

bottom of the device

Device turns on and off while hand

spray gun is closed

Device is not sucking in detergent

Burner does not start

Set temperature is not achieved

while using hot water

Warranty

Accessories and Spare Parts

35

EN