Karcher HD 7-250 De Tr1 - Manual (Page 55)

Allgemeines.pm6.5 - GB
Page 1.5
General
BOGE Operating instructions for CM 9 series screw compressor module
Data
on the type plate
Fig. 1.1: Data on the type plate
1.2 Introduction
BOGE does not accept any liability for breakage or transport damage.
Please inspect the compressor immediately after delivery and direct damage
claims to the last haulier – even when the packing is not damaged!
To safeguard claims against the haulier we recommend leaving the machine,
devices and packing material in the same condition as they were in when
the damage was detected.
In the event of any other complaints, please inform us within six days after
arrival of the delivery.
Enter the data of your compressor from the type plate or enclosed data
sheet in the illustration below. This will ensure that in the event of enquiries,
you will always have the most important data to hand.
Transport damage
Please do not hesitate to contact BOGE service if you have any questions.
Please call:
++49-52 06 / 6 01-0
In the event of inquiries, always specify the following data of your compressor
to prevent any delays.:
– Type
– Year of manufacture
– Machine number
ATTENTION!
Only BOGE service technicians or persons authorized by BOGE in writing
may repair or alter the compressor during the warranty period. Otherwise all
warranty claims will expire!
Service
Type
Year of construction
Serial number
F. a. d.
m 3 /min
Maximum service pressure bar
Motor speed min –1
Motor power kW
Otto-Boge-Straße 1– 7 · D-33739 Bielefeld · Telefon (0 52 06) 6 01-0
Postfach 10 0713 · D-33507 Bielefeld · Fax (0 52 06) 6 01-2 00
www.boge.com · [email protected]