Changing/ replacing filter, Troubleshooting, Indicator lamp "filter blocked" glows – Karcher IV 60-36-3 W User Manual
Page 16: Motor (suction turbine) does not start, Suction capacity decreases slowly, Dust comes out during the vacuuming

– 6
Switch off the appliance using the ON/
OFF switch and separate it from the
mains.
1 Handle for filter cleaning
2 Spring
3 Fastener for filter dedusting
4 Suction head cap
Tilt the fastener for filter dedusting to-
wards the side.
Unscrew the handle for filter shake-off.
Open both the suction head caps.
1 Suction head
2 Frame
3 Filter
Remove the suction hand.
Open the knot of the tapes on the filter
and remove the frame.
Take out the filter.
Insert and secure the new filter in the re-
verse sequence of steps.
ƽ
Danger
Risk of injury by inadvertent startup of ap-
pliance and electrical shock.
First pull out the plug from the mains before
carrying out any tasks on the machine.
You can thus solve any problems that may
occur.
Filter is blocked
Switch off the appliance using the ON/
OFF switch and separate it from the
mains.
Tilt the fastener for filter dedusting to-
wards the side.
Move forcefully the handle for filter de-
dusting in an upward and downward di-
rection.
Place the fastener for filter dedusting in
a vertical position.
If cleaning the filter does not bring any
results, then replace the filter
No electrical voltage.
Check cables, plugs and socket.
Filter, nozzle, suction hose or suction pipe
may be blocked.
Check, clean the accessories, replace
the filter, if required.
Filter has not been fastened correctly or is
defective.
Check to see if filter is sitting properly;
replace if required.
Changing/ replacing filter
Troubleshooting
Indicator lamp "Filter blocked"
glows
Motor (suction turbine) does not
start
Suction capacity decreases slowly
Dust comes out during the
vacuuming
16
EN