Karcher NT 65-2 Tact Tc - Manual (Page 15)

– 4
Caution
Risk of injury and damage! Observe the
weight of the appliance when you transport it.

Remove the suction pipe with the floor
nozzle from the holder. Hold the appli-
ance at the handle and at the suction
pipe to transport it.
 Grab the appliance by the chassis and
by the sliding bow to load it.
 Pull the device behind you at the carry-
ing handle for transporting it over longer
distances
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.
Caution
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.
ƽ
Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
 Open filter door.
 Replace the flat pleated filter.
 Close the filter door, it must lock into
place.
 Release and remove the suction head.
 Clean the electrodes with a brush.
 Insert and lock the suction head.
ƽ
Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
 Check the receptacle and the fuse of
the power supply.
 Check the power cable, the power plug
and electrodes of the device.
 Turn on the appliance.
 Empty the container.
 Turn off the appliance and wait for 5 sec-
onds, turn it on again after 5 seconds.
 Clean the electrodes as well as the
space between the electrodes with a
brush.
 Remove blockages in the suction noz-
zle, suction tube, suction hose, or flat
pleated filter.
 Exchange the paper filter bag.
 Exchange the fleece filter bag (option).
 Ensure the filter cover properly locks
into place.
 Clean or replace the membrane filter
(special accessory) under running water.
 Replace the flat pleated filter.
 Check drain pipe for leaks.
 Check for proper installation of the flat
pleated filter.
 Replace the flat pleated filter.
 Clean the electrodes as well as the
space between the electrodes with a
brush.
 Continuously check the filling level in
case of non-conductive liquid.
Transport
Storage
Maintenance and care
Exchanging the flat pleated filter
Cleaning the electrodes
Troubleshooting
Suction turbine does not run
Suction turbine turns off
Suction turbine does not start again
after the container has been
emptied
Suction capacity decreases
Dust comes out while vacuuming
Automatic shut-off (wet vacuum
cleaning) does not react
15 EN