HID DTC4500 User Guide - Manual (Page 49)

© 2011 HID Global Corporation All rights reserved
DTC4500 Card Printer/Encoder User Guide L001444 Rev1.1
49
Selecting the Advanced Settings tab
Setting Option
Ribbon Calibrate Green This is a calibration driven value and should not be
adjusted.
(Note: This is factory set and should not be changed
unless directed by a technician.)
Ribbon Green LED Level This is a calibration driven value and should not be
adjusted.
(Note: This is factory set and should not be changed
unless directed by a technician.)
Ribbon Calibrate Blue This is a calibration driven value and should not be
adjusted.
(Note: This is factory set and should not be changed
unless directed by a technician.)
Ribbon Blue LED Level This is a calibration driven value and should not be
adjusted.
(Note: This is factory set and should not be changed
unless directed by a technician.)
Ribbon Print Tension Use the Ribbon Tension option to increase or
decreases the amount of tension (drag) on the Ribbon
during printing.
Flipper Home Offset This is a calibration driven value and should not be
adjusted. If the Flipper unit is replaced and has not been
calibrated, this value may need to be adjusted.
(Note: This is factory set and should not be changed
unless directed by a technician.)