Nikon SB-910 - Manual (Page 114)

H–3
H
Tips on Speedlight Care and Reference Information
Troubleshooting
Warning indicator Cause Solution 0
Safety circuit activation
indicator appears.
All functions other than
the power switch are
inoperable because of
power abnormalities. Turn off the power, remove
the batteries, and contact
your retailer or Nikon
representative.
—
The fl ash-ready indicator
blinks after fi ring. Underexposure may have
occurred.
Use a wider aperture or
move the fl ash unit closer
to the subject and reshoot.
C-4
C-7
C-10
C-13
D-20
The remote fl ash unit
beeps for approx.
3 seconds.
Underexposure may have
occurred.
Use a wider aperture, move
the fl ash unit closer to
the subject or change the
position of the fl ash unit
and reshoot.
D-20
Filter detection failure
indicator appears.
The attached color fi lter has
not been detected. Confi rm whether the color
fi lter is correctly attached.
E-14
There is no fl ash output
that corresponds with the
camera aperture used.
Reset the aperture. —
The aperture is not at its
maximum f-number. Set the maximum
f-number.
—
The camera is turned off. Turn the camera on. —
Power zoom function does
not work properly.
Turn the SB-910 off and •
on again.
If the warning indicator
•
remains, contact
your retailer or Nikon
representative.
—