Connecting the dome lights, Positive switched dome lighting – Movies2Go MMD11A User Manual
Page 9

9
CONNECTING THE DOME LIGHTS
The dome lights in the video monitor require three connections to the vehicle's wiring. There are 
two common types of dome light circuits used, positive or negative switched. Positive systems 
supply voltage to the interior lights to turn them on, negative switched systems apply ground to 
illuminate the bulbs. To determine which system you have you must locate the wires at the dome 
light. On a positive switched system, with all the doors closed and the lights out, both wires at the 
dome light will rest at ground. When the light is activated, one of these wires will switch to +12 
vdc. This is the vehicle's switching wire. On a negative switched system, with all the doors 
closed and the lights out, both wires at the dome light will rest at + 12vdc. When the light is 
activated, one of these wires will switch to ground. This is the switching wire. 
For positive systems, connect the purple / brown (Lamp auto) wire to the vehicle's switched wire. 
Then connect the red / black (lamp on) wire to a fused constant 12 volt source and the black / red 
(lamp common) wire to a good ground. Positive systems are commonly found on Ford vehicles.
For negative systems, connect the purple / brown (Lamp auto) wire to the vehicle's switched 
wire. Then connect the red / black (lamp on) wire to a good ground and the black / red (lamp 
common) wire to fused constant 12 volt source. Negative systems are commonly found on 
General Motors and import vehicles.
Note: Some vehicles which incorporate transistorized control of the dome light circuit, such as 
the 1999 Dodge Caravan, may require that the purple / brown (Lamp auto) wire be connected to 
the door pin switch wire, as the additional current draw of the Monitor's lights may not be 
supported by the output of the vehicles body control computer.
Positive Switched Dome Lighting
Red / black - Lamp on
Factory Dome light circuit
To 12 pin
connector
on Monitor
To
constant
+12vdc
To
constant
+12vdc
Black / red - Lamp common
Purple / brown - Lamp Auto
Factory Door ajar
switch or Body
Control computer
