Samsung RF220NCTASP-AA - Manual (Page 17)

setting up _17
01
SETTING UP
Cartridge
Holder
Clip
Filter
cartridge
Plastic line
(Purchased)
• You can purchase the necessary fi lter
cartridge at the retailer where you
purchased this refrigerator.
Water line must be connected to drinkable •
water only
When pushing the Refrigerator back, make
•
sure you don’t roll over the power cord or water
line(Icemaker supply line)
To use without the water fi lter
Connecting to the water supply line
Shut off the main water supply line and turn the •
Ice maker to the off position.
Locate the nearest cold water drinking line.
•
1. Cold Water line
2. Pipe Clamp.
3. Plastic line
4. Compression Nut
5. Compression Sleeve
6. Packing Nut.
7. Shut Off Valve
Connect the water line to the fridge
Slip the compression nut through the plastic 1.
tubing.
After inserting the compression nut into plastic 2.
tubing, tighten the compression nut onto 1/4”
compression fi tting (Purchased).
Do not overtighten the compression nut.
Using Copper Tubing •
Slip the compression nut and ferrule on copper -
tubing as shown.
Using Plastic Tubing
•
Insert the molded end(Bulb) of the plastic tubing -
into the compression fi tting.
Do not use without the molded end(Bulb) of
the plastic tubing.
Tighten the compression nut onto the 3.
compression fi tting.
Turn water on and check for any leakage. 4.
• You can purchase the necessary fi lter
cartridge at the retailer where you
purchased this refrigerator.
Water line must be connected to drinkable •
water only.
When pushing the Refrigerator back, make sure
•
you don’t roll over the power cord or water line
(Icemaker supply line).
Household water line
Compression
Nut (1/4”)
(Purchased)
Compression
fi tting *
Compression
Nut (1/4”) *
Bulb
Plastic Tubing
(Purchased)
(Not supplied) (Not supplied)
Copper tubing or Plastic tubing
Refrigerator
Ferrule
(Purchased)
CAUTION
DA68-02657A.indb 17 2012.7.3 10:53:30 AM
* Accesory included