Airaid 300-165 - Manual (Page 2)

Installation Instructions. Read Me!
1. Disconnect the negative battery
cable. A.) Un-hook the four clips
that hold down the air cleaner lid.
B.) Twist and remove breather
hose from lid.
2. Loosen the hose clamp on the air
filter box lid.
3. Slide the airbox lid forward and
then lift up and remove from
intake hose and vehicle.
4. Remove factory air filter from air
filter box.
5. Install the Quick Fit Panel by
sliding the five tabs on the back
of the panel into the airbox base.
Re-latch two hold down clips.
Slide the factory intake tube onto
the Quick Fit Panel and tighten
the hose clamp.
6. Slide the speed clamp over the
breather hose as shown.
7. Install the breather hose onto the
Quick Fit Panel as shown and
tighten the speed clamp.
8. Install the Airaid Premium Filter
onto the Quick Fit Panel, and
tighten the hose clamp.
9. Install the weather strip on top of
the Quick Fit Panel. (Hint: start
at one end and work your way to
the other end.)
10. Make sure there is no foreign
material in the intake path.
Double check your work for
tightness. Re-connect the
negative battery cable.
A
B