Chatsworth Products Remote Infrastructure Management System Protocol Converter - Manual (Page 48)

RIM-Protocol Converter User Guide - Version 1.0
48 www.chatsworth.com
3.7.3 SNMP
The SNMP Server configuration page allows you to set the System Name (displayed on the home page), System Contact,
and System Location. You can also set up communities that allow multiple SNMP systems to access the Protocol Converter.
Note: To set up communities, you must know the IP address of the SNMP Management System and the Community String.
If necessary, contact your Technical Support department to obtain the IP Address and Community String.
To configure the SNMP server, go to Configuration>SNMP. The SNMP (Server) web page displays.
Configure the fields as necessary.
Figure 3.29 SNMP Server Configuration
Table 3.10 SNMP Configuration Options
Option Description
System Name
An alphanumeric name you assign to the Protocol Converter for SNMP
system integration.
System Contact The person or organization responsible for the Protocol Converter.
System Location An alphanumeric description of the Protocol Converter's location.
Get Community Name The name or type of password used by the SNMP server for Get communications.
Set Community Name
The name or type of password used for the SNMP server that is writing to the
Protocol Converter.
Trap Community Name The name or type of password used by the SNMP server for Trap communications.
Trap Destination IP Address
Enter up to four IP addresses to indicate where the Protocol Converter should
send Trap messages.