LBL Lighting Bare Swivel I User Manual
Bare head swivel i, Install the lamp, Fusion jack

Fusion Jack
™
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
1A
1B
1
2
G
P
I
:
ENERAL
RODUCT NFORMATION
This product is ETL listed and suitable only for indoor dry locations
and approved for use at any height above the finished floor.
Colored and Dichroic lenses, Diffuser and Spread lenses or
Structure louver or Lenseless Clips and Flite paper MR16 are the
compatible accessories.
Installation Instructions for
Bare Head Swivel I
1.3
HBMR16_1A50FSJ
980FSJBRHDSI
1
Install the Lamp
NOTE:
To reduce the risk of a burn or electric shock
during relamping, disconnect the power to the fixture.
Use
Watt MR16 Front Cover
MAX 50
Halogen Lamp.
Align the lamp pins with socket holes.
Push the lamp pins completely into the socket holes.
SOCKET
LAMP
LAMP
SOCKET
ACCESSORY
(OPTIONAL)
Hook one of accessory (optional) tabs onto edge of the MR16
lamp.
Snap the other accessory tab onto opposite edge of the MR16
lamp.
TAB
WARNING:
Risk of Fire. Hot Surface. Install the fixture
at least 6" (Inches) away from wall, curtains and combustible
materials. Maintain at least 9" (Inches) of clearance directly in
front of the fixture.
AVERTISSEMENT: Risque du feu.
Surface Chaude.
Installez le montage au moins 6" (Pouces), 153 mm, loin du
mur, des rideaux et des matériaux combustibles. Maintenez au
moins 9" (Pouces), 230 mm, de dégagement directement
devant le montage.
3
4
2
3
4