beautypg.com

Cleaning & maintenance, Storing the appliance, Calc’nclean plus – Siemens TS22XTRM User Manual

Page 18

background image

18

SIEMENS

ENGLISH

Cleaning &

Maintenance

Attention! Risk of burns!

Always unplug the appliance from the mains

supply before carrying out any cleaning or

maintenance operation on it.

1. After ironing, pull out the plug and allow the

appliance to cool down before cleaning.

2. Wipe the housing, handle and iron body with a

damp cotton cloth.

3. If the soleplate is soiled with dirt or scale, clean

it with a damp cotton cloth.

4. If the cloth is synthetic, it may melt due to the

high temperature on the soleplate (19). Switch

off the steam and rub off any residue

immediately with a thickly folded, dry cotton

cloth.

5. Never use abrasive products or solvents. To

keep the soleplate (19) smooth, you should

avoid hard contact with metal objects. Never

use a scouring pad, or chemicals to clean the

soleplate.

F

Storing the appliance

1. Always allow the appliance to cool down before

storing it.

2. Set the main power button to the “0” position

(the red light will go off) and disconnect the

mains cable.

3. Place the iron on the iron pad (2), standing on

the soleplate, and fix it by inserting the tip of

the iron into the front slot and moving the lock

lever (13) against the heel of the iron.

4. Store the mains cable in the storage

compartment (5) and the steam hose in the

storage fixing (3). Do not wrap the cords too

tight.

5. Use the iron´s handle when moving the

appliance, as shown in figure F.

E

calc’nClean Plus

Cleaning the Boiler

To extend the life of your steam generator and to

prevent any build up of scale, it is essential that

you rinse out the filter (4) and the boiler after

several hours of use. If the water is hard,

increase the frequency.

Do not use descaling agents for rinsing out the

boiler, as they could damage it.

Automatic clean warning

Pilot light (11) will flash indicating that boiler must

be rinsed.

1. Check carefully that the appliance is cold and

unplugged for more than 2 hours, and that the

water tank (1) is empty.

2. Fix the iron to the stand by inserting the tip of

the iron into the front slot and moving the

fixation lever (13) against the heel of the iron.

3. Place your appliance over a sink or bucket.

4. Lean the appliance on the opposite side of the

filter opening.

5. Unscrew the filter (4) and take it out.

6.

(model dependent)

To wash the filter, you may:

a. Place the filter under the water tap and wash it

up until calc residues are removed. Squeeze

the filter as indicated in the picture E.

b. Immerse the filter in tap water (250 ml) mixed

with a measure (25 ml) of descaling fluid.

The descaling fluid can be obtained from our

After-sales service or from our website.

Accessory code

(After-sales)

Name of accessory

(Online shop)

311144

TZ11001

7. Holding your steam generator in the lateral

position and using a jug, fill the boiler with 1/4

litre of water and replace the filter.

8. Shake the base unit for a few moments,

unscrew the filter again and empty the boiler

completely over a sink or bucket.

For best results, we recommend that this

operation is performed twice.

Important: before re-closing, make sure no

water remains in the boiler.

9. Replace and tighten up the filter.

To reset the “calc’nClean” counter, switch the

steam station off twice, keeping it off for at

least 30 seconds each time.

(on → 30s off → on → 30s off → on)

This manual is related to the following products: