Dee Zee DZ16210 - Manual (Page 6)

Page 6 of 8
DZ 16210 04/15/09
Place an 8mm x 20mm Hex Head bolt (C) through running board bracket (B) and start the bolt
into a M8 – 1.25 2 tab weld nut (F) in the front hole location shown below. Then start the 2 rear
hole location bolts (shown below) into a M8 – 1.25 single tab spot weld nut (G). Position
bracket into front driver location with thread plates in vehicle openings and tighten, but do not
tighten completely.
3
C
F
13 mm
G
B
C