Agilent Technologies N3970A - Manual (Page 20)

17
N3970A UM-1
■ S TORING & R ECALLING R EADINGS
The memory location is shown at the top right of the display.
When storing data, the memory automatically increments to
facilitate the collection of data on a job.
You can also go back and over-write particular records.
After the data has been recorded, the entire memory can be
cleared ready for the next job.
Memory operating sequence
Store data in next location: push STORE
Store data starting at a particular location: push SELECT, +/-,
SET, STORE
The memory can not be read in Autotest mode. Exit Autotest
before reading the memory.
Read from any location: push RECALL, +/-. To display the
relative value, push ABS/REL, and to display the reference, hold
down ABS/REL.
Clear the whole memory: push CANCEL and RECALL together
for 2 seconds. CLR will display.